Difference between revisions of "Developing Bridge-compatible stored procedures"
(New page: == Overview == When developing a stored procedure to file patient information into the TouchWorks EHR there are certain parameters that must be included and patient related parameters mus...)
|Line 1:||Line 1:|
== Overview ==
== Overview ==
Revision as of 14:33, 16 November 2012
When developing a stored procedure to file patient information into the TouchWorks EHR there are certain parameters that must be included and patient related parameters must have certain names (e.g. the patient last name field could not be named @PLastName, it must be @LastName or @PatientLastName).
This is applicable to Bridge v2.x, which is compatible with ConnectR v4.6 or greater.
You must include the following:
- @BridgedObjectID: This is an output parameter used to identify the object to which the object was bridged.
- @BridgedEncounterID: This is an output parameter used to identify the encounter associated to which the object was bridged.
- @Status: The status - 0 is success. Negative statuses indicate the type of error, e.g. -100 for patient cannot be identified.
@BridgedObjectID uniqueid = 0 OUTPUT,
@BridgedEncounterID uniqueid = 0 OUTPUT,
@Status int OUTPUT
The following fields must have one of the parameter names included below it. If the parameter is not named correctly, it will not be picked up by Bridge.
Patient Last Name:
Patient First Name:
Patient Middle Name:
MRN (Organization MRN):
MRN (Enterprise MRN):